AutoShield Remote Control Skylight Roof Vent Horsebox Camper Motorhome 420x420mm

The AutoShield skylight roof vent is ideal accessory form the motorhome, camper van or house box which require additional ventilation. It’s also ideal for venting small spaces, the built-in 12V fan provides addition ventilation. 

Made from superior quality impact and UV resistant materials supplied with permanent air flow ventilation system and mosquito screen. Vent is opaque, in white colour with a black top lid, non see through. 

Built in 12v Fan 

Overall vent Size is 420mm x 420mm 

The cut hole needs to be 355mm x 355mm 

Battery not supplied – Must be purchased separately

Please follow the instructions below:

1. Place the internal cap (garnish) on top the roof and draw a template using a felt tip, then add another 5mm to the top and left side.
2. Drill pilot holes in each corner and cut along the template line. Be certain to avoid ribs, braces, and electrical wiring (internally).
3. Check that the internal cap fits through the aperture, if not, cut out opening as needed and then smooth down any rough edges and primer the exposed with metal oxide paint.
4. Make a wooden frame around the aperture to the thickness of the interned finish depth required, taking in to account the roof ply and lining.
5. Glue the frame with Putty Tape and clap in place and allow the adhesive to set.
6. Screw the internal cap to the timber frame and seal around the lip from the top of the roof using flexible putty.
7. Place the external vent over the lip of the internal cap and mark the screw holes with a centre punch. Then remove vent from roof and drill all screw hole locations with a 1/16’’ pilot hole, and seal with primer paint. NOTE: If installing a power or lighted vent, provide power source of 12 volts DC, using 18-gauge wire.
8. Place putty strips bead around the opening on roof ½’’ (1.27cm) from edge of opening. (Be sure putty strips cover entire area to be sealed.) Use double layers of putty strip if necessary, to seal ribbed areas.
9. Insert vent into opening on top of putty strips.
10. Use a screw driver or nail to locate and line up corner drilled holes with the corner screw holes in vent frame. CAUTION: Install vent with lid hinge side toward front of vehicle. Screw corner screws first to hold vent in place then screw all remaining vent mounting screws. Tighten just enough to compress putty tape. Over-tightening may cause Plastic Base Vents to crack.
11. Using the appropriate roof coating for your roof surface, coat screw heads and vent frame edge and seal around the frame if necessary.
12. Your installation is complete.

You can view the rest of our roof vents through the following link – You searched for ROOF VENT | Shield Auto Care