Stick and seal hybrid polymer adhesive and sealant is a one part, solvent-free adhesive based on the latest polymer technology.
It has excellent UV resistance and primerless adhesion to most substrates. It cures to be a tough, elastic adhesive sealant with applications across a range of industries. The cured sealant has good abrasion, oil and solvent resistance.
Application: Construction uses include perimeter sealing of plastic, timber and metal frames along with the sealing of expansion and construction joints; it may be used on moist surfaces. The product is also suitable for many applications within the automotive, roofing, marine and coachwork industries. Suitable for sealing and bonding connection joints in ducting, ventilation and air conditioning installations, ideal for camper cassette window use.
COVERAGE: 1 std size cartridge is sufficient to seal approximately 10m with a 6mm bead.
Limitations: Stick and seal hybrid polymer sealants should not be used to seal aquariums. Submerged joints need special attention to surface preparation and application and should be checked for integrity at regular intervals. Always check to determine suitability of the sealant on any surface that may give cause for concern.
TECHNICAL DETAILS:
Type: Hybrid Polymer
Skinning Formation Time: Approx. 40 minutes (at 23oC and 50% relative humidity).
Cure rate: Approx. 3mm per 24Hrs As the joint depth increases, the cure rate will slow down.
Movement accommodation: ±20% Flow
Frost Resistance During Transport: Up to -15
Application Temp Range: +5ºC to +35ºC.
Service Temp Range: -40ºC to +100ºC.
Life Expectancy: When used and applied correctly the sealant will perform in excess of 20 years.
APPLICATION INSTRUCTIONS: Surfaces to which Sealant is to adhere must be clean and free from loose material, standing water or contaminants. Non-porous surfaces such as aluminum should be cleaned with a suitable product. It may be necessary to prime some porous surfaces depending on cohesiveness and porosity of the substrate.
For application where some movement will be exhibited i.e. construction joints, the minimum joint dimensions should be 6mm x 6mm with the maximum dimensions being 20mm wide by 12mm deep. Where deeper joints are found, depth can be reduced using a suitable backer rod.
Areas of perimeter pointing where a fillet is to be applied, the minimum measurement across must be 10mm with a minimum depth of 6mm. If conditions are suitable for application, ensure joints are properly prepared and apply sealant firmly into the joint using an application gun. Ensure a good solid fill is achieved. Once applied, sealant can be tooled within 10 minutes to required finish. The cured sealant can be painted if required.
Reviews
There are no reviews yet.